Square At Impact Is A Myth

Believe it or not, the long-held belief that the clubface must be square through the hitting zone to hit straight shots is a myth. Over the past 10 years, I’ve measured the activity of the clubface during Tour players’ swings through the impact zone, and what I’ve learned is that not a single player holds the Mizuno MX-25 Irons square during the hitting area. Not one! In fact, these top-level players rotate the face counterclockwise around the shaft (for right-handed players) at about 30 degrees per foot of linear motion forward.

 

Put another way, the clubface is 30 degrees open 12 inches from the center of the ball before impact and 30 degrees closed 12 inches past where the center of the ball was after impact. This means that the clubface is only square when it reaches a point somewhere near the center of the golf ball. It also means that when the clubface first touches the ball, it’s actually open instead of square.

 

If your face is square when it first touches the Titleist CB 710 Forged Irons, you get the right degrees counterclockwise to face, you will get a six-degree hook, starting on the left of the target and further to the left hook. Conversely, if the club open to the ball six times with the contact surface, which will apply to the first 6 slices degree rotation. This will be negative, but the hook from six deformation phases in the application of rotation. The result is a net zero side spin, straight bar. 

 

If you strike the ball with the face anywhere in the three- to nine-degree open range, you’ll hit a perfectly acceptable golf shot. It should be reassuring to know that a six-degree variation at impact will produce decent results. In measuring Tour players’ face angles at impact, I found a five-degree variation, shot to shot.

 

Put these new concepts to the test the next time you visit the range. Address the ball with the face six to 10 degrees open, instead of square. Turn the shaft counterclockwise through the impact zone and observe the resulting ballflight. If the Taylormade R9 Forged Irons flies left, you turned the face too soon. If it goes right, you turned the face too late. Keep hitting shots and observing ballflight until you have a sense of the face hitting the ball at the right time with the proper angle. Once you find the right amount of rotation for your swing, hitting accurate shots will become a lot easier.

BOLA TANGKAS
{youtube|100|campaign}